|
|
|
| Usually caused by | Cured by |
| Air pressure too high. | Adjust air pressure. |
| Wax pot low on wax. | Add wax. Be sure that wax pot is more than ½ full. |
| Wax too hot or cold. | Adjust temperature and stir wax to release trapped air. |
| Mould held at wrong angle to nozzle. | Hold mould on same plane as nozzle. |
| Casting problems | |
| Wax pattern problems | |
| Mould rubber problems | |
| Mixing guide | |
| De-wax and burnout cycles | |
| Sitemap | |
