|
|
|
| Usually caused by | Cured by |
| Investment too thick. Too little water. | Use correct powder / water ratio. |
| Vacuum pump/ tank faulty. | Ensure equipment is regularly serviced and adequate for the task. |
| Work cycle too long. Investment beginning to set while still under vacuum. | Ensure the work cycle is not too long and slurry temperature is 20- 22oC |
| Casting problems | |
| Wax pattern problems | |
| Mould rubber problems | |
| Mixing guide | |
| De-wax and burnout cycles | |
| Sitemap | |
