|
|
|
|
||||||||||||||||||||||||||||||||||||||||||||||
| Conventional mixing | |||||||||
| Vacuum mixing | |||||||||
| Mixing instructions | |||||||||
|
|||||||||
| Sitemap | |||||||||
1
Determine the weight of powder and the volume of water.
2
Weigh out the powder and measure its temperature.
3
Adjust the water temperature so as to give a slurry temperature of 20ºC.
4
Measure the required volume of water into a clean mixing bowl.
5
Add the powder to the water.
6
Mix by hand for 30 seconds, to break up any lumps.
7
Mix by machine for a further 3 minutes.
8
Vacuum the investment in the bowl (not more than 2 minutes).
9
Pour the investment slowly down the side of the flask until the wax patterns are covered.
10
Vacuum the investment in the flask (not more than 2 minutes).
11
Let the flask stand undisturbed (at least 1 hour is best).
12
Remove sprue base and collar.
13
Place flask in furnace and follow an appropriate burn-out cycle. DO NOT EXCEED 740ºC.
14
Cast with metal.
